Beauty and the Beast Bell Jars

April 28
No comments yet
*

Last week at work I had the opportunity to host an event for our volunteers. With the recent release of the new live action Beauty and the Beast movie I had the idea to tie the event to that theme. I mean Bell loves books, right? So of course I wanted to recreate the iconic rose for the centerpeoces. 

After some searching around this is what I came up with. It’s super simple inexpensive which is great if you need several like I did. Read on to see how I made them. 


Supplies:
2 liter soda bottles
1.5 in foam balls 
Black paint 
Black felt 
Roses
X-acto knife
Scissors
Goo Gone

Several hours before you need your completed project paint the styrofoam balls with the acrylic paint. You can use whatever paint you like except for spray paint as it ruins foam. I used the cheap little bottles of acrylic paint from the craft store.

Remove the label from the 2 liter bottle. I cut it off then used goo gone to remove the label. TIP:  If you are just buying the 2 liter for this project select one with a clear label as opposed to a colored one as they seem to leave less adhesive. Next saturate the adhesive reside with goo gone and let sit for a minute. After that use a coin or your nails to remove the goo. Wipe down the bottle to remove residual product.

Next grab an x-acto knife and puncture the bottle near the bottom.  You can then use the knife or good scissors to cut the bottom of the bottle off. I found that many bottles had a little seam there which made cutting easy. After you’ve removed the bottom set the bottle on a table to ensure it is fairly even. Remember that we are using felt on the bottom so if there is a small jagged part it is going to be alright.

Now that the jar is nice and cut it is time to make the lid. Remove the cap from the bottle and the plastic ring. I found that it was easy to use scissors to pry the plastic ring off.

Now you will want to cut your styrofoam balls. I cut mine about 1/3 of the way in. I then gouged out the insides so that it would fit on the top. I used an x-acto knife to do this, just be careful! Next carefully push the ball onto the top of the bottle. If you push too hard it could break.At this point I grabbed some windex and cleaned the inside and the outside of the bottle, removing any remaining fingerprints or debris.

Now it is time to grab your flower. Cut your flower so that it fit in the bottle with the bottom resting on the table and the flower appearing near the top of the bottle. If your flower has movable leaves feel free to move them around to your liking. The fuller the jar looks the better.

It is now time to grab the felt and cut a circle that is about 1-2 inches wider in diameter than your bottle and place the circle under the bottle.

You’re done!


I used these as centerpieces. The tables were decorated with red and dark blue tablecloths with book pages spread like a table runner for accent. Rose petals would look lovely as well.

What do you think? Share below! 
Disclosure: This post contains affiliate links. If you purchase an item via a link from the page I will receive a small commission. This does not affect the price you pay for the item. In fact, I research the best prices for my site. All printables are free. Enjoy!

*
RELATED POSTS

Your email address will not be published. Required fields are marked *